From a2f92f02abaae9df68759586102438df6f8d5efb Mon Sep 17 00:00:00 2001 From: Samuel Holland Date: Sat, 9 Oct 2021 10:43:56 -0500 Subject: [PATCH 02/13] binman: Prevent entries in a section from overlapping Currently, if the "offset" property is given for an entry, the section's running offset is completely ignored. This causes entries to overlap if the provided offset is less than the size of the entries earlier in the section. Avoid the overlap by only using the provided offset when it is greater than the running offset. The motivation for this change is the rule used by SPL to find U-Boot on sunxi boards: U-Boot starts 32 KiB after the start of SPL, unless SPL is larger than 32 KiB, in which case U-Boot immediately follows SPL. Signed-off-by: Samuel Holland --- tools/binman/entry.py | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/tools/binman/entry.py b/tools/binman/entry.py index 70222718ea93..61822eb5e44f 100644 --- a/tools/binman/entry.py +++ b/tools/binman/entry.py @@ -404,7 +404,9 @@ class Entry(object): if self.offset_unset: self.Raise('No offset set with offset-unset: should another ' 'entry provide this correct offset?') - self.offset = tools.align(offset, self.align) + elif self.offset > offset: + offset = self.offset + self.offset = tools.align(offset, self.align) needed = self.pad_before + self.contents_size + self.pad_after needed = tools.align(needed, self.align_size) size = self.size -- 2.33.0